CRUISE CONTROL SYSTEM (for 1WW) TC and CG Terminal Circuit

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

   
   

   1. Disconnect the A76 ECM connector.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition H16-13 (TC) - A76-50 (TC) Always Below 1 Ω H16-4 (CG) - Body ground H16-13 (TC) - Body ground Always 10 kΩ or higher

   
   
   • OKClick here
   • NGClick here
2. Click here

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

3. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR