CRUISE CONTROL SYSTEM (for 1WW) Cruise Main Indicator Light Circuit

DESCRIPTION

• When the driving support ECU detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter through CAN communication. Then the cruise control indicator light turns on.

• The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   PERFORM ACTIVE TEST USING GTS (CRUISE CONTROL INDICATOR LIGHT)

   
   

   1. Select the item below in the Active Test, and then check that the cruise control indicator light illuminates (Click here).

      Table 1. Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	Cruise control indicator light	ON/OFF	-

      OK
      Indicator light turns on/off.

   
   
   • OKClick here
   • NGClick here
2. Click here

   READ VALUE USING GTS (CRUISE CONTROL MAIN SWITCH)

   
   

   1. Use the Data List to check if the cruise control indicator light is functioning properly (Click here).

      Table 2. Cruise Control

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Cruise Control Main Switch	Cruise control main switch / ON or OFF	ON: Cruise control main switch on OFF: Cruise control main switch off	-

      OK
      On screen, item changes between ON and OFF according to above chart.

      Table 3. Result

      Result	Proceed to
      OK	A
      NG (for LHD)	B
      NG (for RHD)	C

   
   
   • AClick here
   • BClick here
   • CClick here
3. Click here

   GO TO METER / GAUGE SYSTEMClick here

4. Click here

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

5. Click here

   REPLACE DRIVING SUPPORT ECUClick here

6. Click here

   REPLACE DRIVING SUPPORT ECUClick here