RELAY ON-VEHICLE INSPECTION


  1. INSPECT STARTER RELAY (ST)


    1. A01INA8E26

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the starter relay.

  2. INSPECT ACC RELAY (ACC)


    1. A01INA8E26

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the ACC relay.

  3. INSPECT GLOW RELAY


    1. A01IRWV

      Remove the bolt.

    2. Disconnect the connector and remove the glow relay.

    3. A01IQN5E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Battery voltage not applied to terminals 3 and 4 10 kΩ or higher
      Battery voltage applied to terminals 3 and 4 Below 1 Ω

      If the result is not as specified, replace the glow relay.

    4. Connect the connector.

    5. Install the glow relay with the bolt.

      Torque:
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }