STARTER INSTALLATION


  1. INSTALL FLYWHEEL HOUSING SIDE COVER


    1. Install the flywheel housing side cover to the cylinder block.

  2. INSTALL STARTER ASSEMBLY


    1. Install the starter with the 2 bolts.

      Torque:
      37 N*m  { 380 kgf*cm, 27 ft.*lbf }

    2. Connect the connector.

    3. Connect the starter wire with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Close the terminal cap.

  3. INSTALL BATTERY CARRIER


    1. A01IN2I

      Install the battery carrier with the 4 bolts.

      Torque:
      19 N*m  { 189 kgf*cm, 14 ft.*lbf }
    2. A01INC1

      Install the radiator pipe with the 2 bolts.

      Torque:
      19 N*m  { 189 kgf*cm, 14 ft.*lbf }

    3. Connect the 2 wire harness clamps.

  4. INSTALL BATTERY TRAY

  5. INSTALL BATTERY

  6. INSTALL BATTERY CLAMP SUB-ASSEMBLY


    1. A01IQN6E01

      Install the battery clamp with the bolt and nut.

      Torque:
      for bolt
      17 N*m  { 169 kgf*cm, 12 ft.*lbf }
      for nut
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

    2. Connect the cable to the positive (+) battery terminal.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A01IPUC

      Connect the air cleaner cap with the band.

    2. Connect the PCV hose.

    3. A01IP4V

      Connect the 2 clamps.

    4. A01ISEG

      Attach the 2 clamps and connect the wire harness.

    5. Connect the mass air flow meter connector.

  8. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01ISXU

      Install the under cover with the 11 clips and 6 bolts.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL RADIATOR SUPPORT OPENING COVER


    1. A01IU5G

      Attach the 4 hooks to install the radiator support opening cover.

    2. Install the 5 clips.

  11. INSTALL BATTERY SERVICE HOLE COVER


    1. A01IPWV

      Install the battery service hole cover with the clip.

  12. INSTALL NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Attach the 4 clips to install the cover.

      Note


      • Be sure to attach the clips securely.

      • Do not apply excessive force or hit the cover to attach the clips. This may cause the cover to break.