Click here

STARTER REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note:

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. Click here

    REMOVE BATTERY SERVICE HOLE COVER


    1. A01IPWV

      Remove the clip and battery service hole cover.

  3. Click here

    REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IU5G

      Remove the 5 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  4. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  5. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  6. Click here

    REMOVE NO. 1 ENGINE UNDER COVER


    1. A01ISXU

      Remove the 11 clips, 6 bolts and under cover.

  7. Click here

    REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01ISEG

      Disconnect the mass air flow meter connector.

    2. Detach the 2 clamps and disconnect the wire harness.

    3. A01IP4V

      Disconnect the 2 clamps.

    4. A01IPUC

      Disconnect the PCV hose.

    5. Loosen the band and remove the air cleaner cap.

  8. Click here

    REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A01IQN6E01

      Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

  9. Click here

    REMOVE BATTERY

  10. Click here

    REMOVE BATTERY TRAY

  11. Click here

    REMOVE BATTERY CARRIER


    1. A01INC1

      Disconnect the 2 wire harness clamps from the battery carrier.

    2. Remove the 2 bolts and disconnect the radiator pipe from the battery carrier.

    3. A01IN2I

      Remove the 4 bolts and battery carrier.

  12. Click here

    REMOVE STARTER ASSEMBLY


    1. Open the terminal cap.

    2. A01IPMOE01

      Remove the nut and disconnect the starter wire.

    3. Disconnect the connector.

    4. Remove the 2 bolts and starter.

  13. Click here

    REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A01IN7N

      Remove the flywheel housing side cover from the cylinder block.