GLOW PLUG REMOVAL


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Remove the clip and battery service hole cover.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY


    1. A01IN22

      Remove the 3 bolts, 2 nuts and No. 2 EGR pipe.

    2. Remove the 2 gaskets.

  6. REMOVE ENGINE COVER BRACKET


    1. A01IS0W

      Remove the bolt, nut and engine cover bracket.

  7. DISCONNECT ENGINE WIRE


    1. A01IN4J

      Remove the bolt disconnect the engine wire so that the glow plugs can be removed in a later step.

  8. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. A01IOVD

      Remove the 5 grommets.

    2. A01IP2FE01
      Text in Illustration
      *1 Wire Harness

      Remove the nut and disconnect the wire harness.

    3. Remove the 4 nuts and No. 1 glow plug connector.

  9. REMOVE GLOW PLUG ASSEMBLY


    1. A01IQBH

      Using a 10 mm deep socket wrench, remove the 4 glow plugs.