ENGINE OIL COOLER INSTALLATION


  1. INSTALL OIL CHECK VALVE SUB-ASSEMBLY


    1. Install the 2 oil check valve sub-assemblies and 2 new gaskets to the oil filter assembly.

  2. INSTALL OIL COOLER COVER SUB-ASSEMBLY


    1. Using a T8 "TORX" socket wrench, install the oil cooler cover sub-assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL OIL FILTER ASSEMBLY


    1. Install a new gasket to the oil filter assembly.

    2. Install the oil filter assembly with the 6 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

  4. INSTALL OIL FILTER SUB-ASSEMBLY


    1. Clean the inside of the oil filter cover, its threads and its O-ring.

    2. A01IPC9E01
      Text in Illustration
      *1 O-Ring
      *a CORRECT
      *b INCORRECT

      Apply a small amount of engine oil to a new O-ring and install it to the oil filter cover.

      Note


      • Be sure to install the O-ring in the proper location, otherwise oil may leak.

      • Do not twist the O-ring.

    3. Apply a light coat of engine oil to a new O-ring.

    4. A01IPRLE01
      Text in Illustration
      *1 O-Ring
      *a Oil Filter Assembly Hole
      A01ISM9 Protrusion

      Install the O-ring to the oil filter sub-assembly.

    5. Set a new oil filter sub-assembly in the oil filter assembly.

      Note

      Insert the protrusion of the oil filter sub-assembly into the oil filter assembly hole.

    6. Apply a small amount of engine oil to the O-ring again and temporarily install the oil filter cover.

    7. A01IOE0E01
      Text in Illustration
      *1 Oil Filter Assembly
      *2 O-Ring
      *3 Oil Filter Cover
      *a No Gap

      Using a 27 mm socket wrench, tighten the oil filter cover.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      After tightening the oil filter cover, make sure that there is no gap and that the O-ring is not protruding.

  5. INSTALL INTAKE MANIFOLD

    Click here

  6. ADD ENGINE OIL


    1. Add new engine oil.

      Standard engine oil
      Toyota recommends the use of approved "Toyota Genuine Motor Oil 5W-30 Premium Fuel Economy for 1WW/2WW engines" or equivalent.
      Standard capacity (Drain and refill with oil filter change)
      5.2 liters (5.5 US qts, 4.6 Imp. qts)

  7. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.