OIL PRESSURE SENSOR (for DPF) REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01IUJJ

      Remove the 9 clips and fold back the No. 1 engine under cover.

      Tech Tips

      It is not necessary to fully remove the No. 1 engine under cover. Partially remove it so that the oil can be replaced in a later step.

  2. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

    3. Install a new gasket and the oil pan drain plug.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

  3. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  4. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IS0M

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  5. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Disconnect the oil pressure sender gauge connector.

    2. A01IQY0

      Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.