RELAY ON-VEHICLE INSPECTION


  1. INSPECT COOLING FAN RELAY


    1. Remove the relay from the engine room No. 1 relay block.

    2. A01IP5RE02

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the cooling fan relay.

    3. Install the relay to the engine room No. 1 relay block.