EXHAUST MANIFOLD REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    1. Remove the windshield wiper motor and link Click here.

  3. REMOVE OUTER COWL TOP PANEL


    1. A01IOGQE01

      Disconnect the connector clamp.

    2. Remove the 9 bolts and outer cowl top panel.

  4. REMOVE AIR FUEL RATIO SENSOR


    1. A01IQFV

      Disconnect the sensor connector and clamp.

    2. A01IOPNE01

      Using SST, remove the sensor from the exhaust manifold.

      SST
      09224-00010

      Note

      Do not damage the sensor.

  5. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01INBM

      Remove the bolt and wire harness clamp bracket.

  6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01IUNH

      Remove the 4 bolts and No. 1 exhaust manifold heat insulator.

  7. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01IPUX

      Using a clip remover, remove the 4 clips and No. 2 engine under cover.

  8. REMOVE FRONT FLOOR CENTER BRACE

    A01IP00

    1. Remove the 4 bolts and front floor center brace.

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Detach the clamp and disconnect the heated oxygen sensor wire harness.

    2. Disconnect the heated oxygen sensor connector.

    3. A01ISEX

      Remove the 2 bolts and 2 compression springs.

    4. A01IRWB

      Remove the 2 bolts and 2 compression springs.

    5. Remove the 3 exhaust pipe supports and front exhaust pipe assembly.

  10. REMOVE DRIVE SHAFT HEAT INSULATOR SUB-ASSEMBLY


    1. A01IMZJ

      Remove the 2 nuts and drive shaft heat insulator sub-assembly.

  11. REMOVE MANIFOLD STAY


    1. A01IUFS

      Remove the 3 bolts and manifold stay.

  12. REMOVE EXHAUST MANIFOLD


    1. A01IPK7

      Remove the 5 nuts and exhaust manifold.

    2. Remove the exhaust manifold gasket.

  13. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01INVO

      Remove the 4 bolts and No. 2 exhaust manifold heat insulator.