EXHAUST PIPE INSTALLATION


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. Check the free length of the compression spring.


      1. A01IN16

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length
        41.5 mm (1.63 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Connect the front exhaust pipe to the 3 exhaust pipe supports.

    3. Install a new gasket to the front exhaust pipe.

    4. Install the front exhaust pipe with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  2. INSTALL AIR FUEL RATIO SENSOR (for DPF)


    1. A01IUJVE02

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • Make sure SST and the wrench are connected in a straight line.

    2. Connect the air fuel ratio sensor connector and clamp.

    3. A01ION5

      Install the harness clamp.

  3. INSTALL FRONT FLOOR CENTER BRACE


    1. A01IOAZ

      Install the front floor center brace with the 4 bolts.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }

  4. INSTALL NO. 2 ENGINE UNDER COVER


    1. A01IOL8

      Install the No. 2 engine under cover with the 4 clips.

  5. INSTALL TAILPIPE ASSEMBLY


    1. Check the free length of the compression spring.


      1. A01IN16

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length
        38.5 mm (1.52 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Connect the tailpipe to the 2 exhaust pipe supports.

    3. Install a new gasket to the front exhaust pipe.

    4. Install the tailpipe with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  6. INSPECT FOR EXHAUST GAS LEAK


    1. Check that there are no exhaust gas leaks from the points (connection areas of the exhaust pipes and installation areas of each sensor) shown in the illustration.

      A01IN0ZE01