EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2) INSTALLATION


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2)

    Note

    If the exhaust gas temperature sensor is dropped, replace it with a new one.


    1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    2. Pass the sensor harness through the hook on the cylinder head cover side.

    3. Connect the sensor harness to the bracket clamp.

    4. Connect the exhaust gas temperature sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

  3. INSTALL NO. 1 ENGINE COVER


    1. A01IQK8E02
      Text in Illustration
      *a Installation Points

      Attach the 4 clips to install the No. 1 engine cover.

      Tech Tips

      When attaching the clips, press the protrusions on the top of the No. 1 engine cover at the clip installation points.