EXHAUST GAS TEMPERATURE SENSOR (for Sensor 1) REMOVAL


  1. REMOVE NO. 1 ENGINE COVER


    1. A01IRDDE01

      Lift the No. 1 engine cover to detach the 4 clips in the order shown in the illustration and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover to break.

  2. DISCONNECT VACUUM CONTROL VALVE BRACKET


    1. A01IQL8

      Disconnect the exhaust gas temperature sensor connector.

    2. Detach the wire harness clamp.

    3. A01ISPFE01
      Text in Illustration
      *a Air Fuel Ratio Sensor Connector
      *b Exhaust Gas Temperature Sensor Connector
      *c Clamp

      Disconnect the exhaust gas temperature sensor connector.

    4. Disconnect the air fuel ratio sensor connector.

    5. Raise the air fuel ratio sensor connector from the vacuum control valve bracket.

    6. Move the clamp as shown in the illustration, and disconnect the air fuel ratio sensor and exhaust gas temperature sensor.

      Note

      Disconnect the sensors while opening the clamp.

    7. Detach the air fuel ratio sensor clamp from the vacuum control valve bracket.

    8. A01IUEI

      Using a T20 "TORX" socket wrench, remove the 3 screws and disconnect the vacuum control valve bracket.

  3. REMOVE NO. 1 TURBO INSULATOR


    1. A01IQ49

      Remove the 3 bolts, nut and No. 1 turbo insulator.

  4. REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Sensor 1)

    Note

    If the exhaust gas temperature sensor is dropped, replace it with a new one.


    1. A01ITCT

      Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor.