MONOLITHIC CONVERTER REMOVAL


  1. REMOVE AIR FUEL RATIO SENSOR


  2. REMOVE EXHAUST GAS TEMPERATURE SENSOR


  3. REMOVE DIFFERENTIAL PRESSURE SENSOR

    Click here

  4. REMOVE HEATER WITH EXHAUST PIPE ASSEMBLY (w/ Combustion Type Power Heater)

    Click here

  5. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

    Click here

  6. REMOVE OUTER COWL TOP PANEL


    1. A01IO5B

      Remove the 9 bolts and outer cowl top panel.

  7. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01IOL8

      Remove the 4 clips and No. 2 engine under cover.

  8. REMOVE FRONT FLOOR CENTER BRACE


    1. A01IOAZ

      Remove the 4 bolts and front floor center brace.

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the 4 bolts and 4 compression springs.

    2. Disconnect the front exhaust pipe assembly from the 3 exhaust pipe supports.

    3. Remove the 2 gaskets.

  10. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01IQ35

      Detach the 2 clamps and disconnect the engine wire.

    2. Remove the 2 bolts and No. 1 exhaust manifold heat insulator.

  11. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    1. A01IP2Y

      Remove the 2 bolts, 2 nuts and manifold stay.

    2. A01IODI

      Loosen the V-band clamp.

    3. Remove the 3 nuts, 3 bolts, V-band clamp, gasket, engine bracket and exhaust manifold converter sub-assembly.

      A01IRPGE01
      Text in Illustration
      *1 Engine Bracket *2 Exhaust Manifold Converter Sub-assembly
      *3 No. 2 Manifold Stay - -