EXHAUST FUEL ADDITION INJECTOR (for DPF) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  4. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01IOT2

      Detach the clamp and disconnect the mass air flow meter connector.

    2. Slide the clamp and disconnect the PCV hose from the cylinder head cover sub-assembly.

    3. Slide the clamp and disconnect the air cleaner hose assembly from the turbocharger sub-assembly.

    4. Detach the 4 clamps and remove the air cleaner cap sub-assembly.

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ITZL

      Remove the 3 bolts and air cleaner case.

  8. DISCONNECT WIRE HARNESS


    1. A01ISPW

      Disconnect the 5 connectors and detach the 3 wire harness clamps.

    2. Remove the bolt from the fuel hose protector.

  9. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01IPU8

      Remove the bolt and wire harness clamp bracket.

  10. REMOVE FUEL HOSE PROTECTOR


    1. A01INWG

      Remove the bolt and fuel hose protector.

  11. REMOVE FUEL TUBE SUB-ASSEMBLY


    1. A01IT57

      Disconnect the exhaust fuel addition injector connector.

    2. A01IQ6B

      Turn the retainer as shown in the illustration.

    3. A01IUL8

      Disconnect the fuel tube sub-assembly from the exhaust fuel addition injector assembly.

    4. A01INMW

      Remove the check valve and gasket.

      Text in Illustration
      A01ISER Check Valve

    5. Remove the union bolt, gasket and fuel tube sub-assembly.

  12. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY


    1. A01IQULE01
      Text in Illustration
      *1 Washer
      *2 Nozzle Holder Clamp

      Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector assembly and gasket.

  13. REMOVE FUEL INJECTOR SEAL


    1. A01IR8Q

      Remove the fuel injector seal from the exhaust fuel addition injector assembly.