EGR VALVE REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Remove the 6 bolts and 10 clips.

    2. Remove the No. 1 engine under cover.

  2. DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the radiator reservoir cap.

      CAUTION:

      Do not remove the radiator reservoir cap and air release plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

      A01IUC4E01
      Text in Illustration
      *1 Radiator Reservoir Cap *2 Air Release Plug
      *3 Radiator Drain Cock Plug - -

  3. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  4. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IS0M

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  5. REMOVE EGR VALVE BRACKET


    1. A01IPQ0

      Disconnect the 2 connectors and detach the 2 wire harness clamps.

    2. A01IPI2

      Remove the 3 bolts and 2 EGR valve brackets.

  6. DISCONNECT NO. 7 WATER BY-PASS HOSE

    A01ITX7

    1. Slide the clamp and disconnect the No. 7 water by-pass hose from the electric EGR control valve assembly.

  7. DISCONNECT NO. 8 WATER BY-PASS HOSE

    A01INDM

    1. Slide the clamp and disconnect the No. 8 water by-pass hose from the electric EGR control valve assembly.

  8. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY


    1. A01IOQA

      Disconnect the electric EGR control valve connector.

    2. A01IPRKE01
      Text in Illustration
      *1 Nut

      Remove the 3 bolts, 2 nuts, No. 2 EGR pipe sub-assembly and 2 gaskets.

  9. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY


    1. A01IQP8

      Remove the electric EGR control valve assembly and gasket.