Click here

FUEL TEMPERATURE SENSOR REMOVAL

Click here
Click here Click here
Note:

When working on the fuel circuit, protect the generator assembly against dirt contamination.

Cover the generator assembly with suitable materials.

Failure to comply with this procedure may result in a generator assembly malfunction.

Click here
  1. Click here

    REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IPK0

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. Click here

    REMOVE NO. 1 ENGINE COVER


    1. A01IRDDE01

      Lift the No. 1 engine cover to detach the 4 clips in the order shown in the illustration and remove the No. 1 engine cover.

      Note:

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover to break.

  3. Click here

    REMOVE FUEL TEMPERATURE SENSOR


    1. A01IPIT

      Disconnect the fuel temperature sensor connector.

    2. Using a 17 mm (12P) deep socket wrench, remove the fuel temperature sensor from the fuel feed line.

    3. Remove the O-ring from the fuel temperature sensor.