FRONT CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE BATTERY SERVICE HOLE COVER


    1. A01IPWV

      Remove the clip and battery service hole cover.

  3. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IU5G

      Remove the 5 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  4. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01ISXU

      Remove the 11 clips, 6 bolts and under cover.

  5. REMOVE REAR ENGINE UNDER COVER RH


    1. A01IP88

      Remove the 5 clips and under cover RH.

  6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01IOXU

      Remove the 4 bolts and front suspension member reinforcement RH.

  7. REMOVE V-RIBBED BELT


    1. A01ITH6E01

      Loosen bolts A and B.

    2. Loosen bolt C and remove the V-ribbed belt.

      Note

      Do not loosen bolt D.

  8. REMOVE CRANKSHAFT PULLEY


    1. A01IUGJE01
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      09330-00021

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A01IQIIE01
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply lubricant to the threads and end of SST.

  9. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A01IPZOE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, pry out the oil seal.

      Tech Tips

      Tape the screwdriver tip before use.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.