Click here

CYLINDER BLOCK REPLACEMENT

Click here
Click here Click here
  1. Click here

    REPLACE RING PIN

    A01IU35E11
    Note:

    It is not necessary to remove a ring pin unless it is being replaced.


    1. Using a plastic-faced hammer, tap in the ring pins.

      Standard Ring Pin
      Item Height Width Protrusion
      Ring pin 14.3 to 14.7 mm (0.563 to 0.579 in.) 12.9 to 13.0 mm (0.508 to 0.512 in.) 7.5 to 8.5 mm (0.295 to 0.335 in.)
  2. Click here

    REPLACE STRAIGHT PIN

    Note:

    It is not necessary to remove a straight pin unless it is being replaced.


    1. Using a plastic-faced hammer, tap in the straight pins.

      Standard Straight Pin
      Item Height Width Protrusion
      Pin A 36 mm (1.417 in.) 10 mm (0.394 in.) 18.5 to 19.5 mm (0.728 to 0.768 in.)
      Pin B 12 mm (0.472 in.) 4 mm (0.156 in.) 5.0 to 7.0 mm (0.197 to 0.276 in.)
      Pin C 22 mm (0.866 in.) 10 mm (0.394 in.) 11 to 13 mm (0.433 to 0.512 in.)
      Pin D 18 mm (0.708 in.) 8 mm (0.315 in.) 8.0 to 10.0 mm (0.315 to 0.394 in.)
      Pin E 12 mm (0.472 in.) 4 mm (0.156 in.) 5.0 to 6.0 mm (0.197 to 0.236 in.)
  3. Click here

    REPLACE CONNECTING ROD SMALL END BUSH


    1. A01IQN0E01

      Using SST and a press, press out the connecting rod small end bush.

      09222-30010
    2. A01IP1VE02

      Align the oil holes of a new connecting rod small end bush and the connecting rod.

      Table 1. Text in Illustration
      *1 Oil Hole
    3. A01IQN0E01

      Using SST and a press, press in the connecting rod small end bush.

      09222-30010
    4. A01IN97

      Using a pin hole grinder, hone the bush to obtain the standard oil clearance between the bush and piston pin.

      Standard oil clearance
      0.005 to 0.011 mm (0.000197 to 0.000433 in.)
    5. A01IUHI

      Coat the piston pin with engine oil. Push the piston pin into the connecting rod with your thumb to check that the piston pin fits at normal room temperature.