Click here

REAR CRANKSHAFT OIL SEAL REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

    (Click here)

  4. Click here

    REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

    (Click here)

  5. Click here

    REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)


    1. A01IRLCE01

      Place matchmarks on the clutch cover and flywheel.

      Table 1. Text in Illustration
      *1 Matchmark

    2. Loosen each set bolt 180° at a time until the spring tension is released.

      Note:

      Be sure to uniformly loosen the bolts 180° at a time according to the order in the illustration.

    3. Remove the set bolts and pull off the clutch cover to remove it.

      Note:

      Do not drop the clutch disc.

  6. Click here

    REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Note:

    Keep the lining part of the clutch disc, the pressure plate, and the surface of the flywheel away from oil and foreign matter.

  7. Click here

    REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    1. A01IPB5E01

      Using SST, hold the crankshaft pulley.

      09213-58014 91551-80840
      09330-00021
    2. A01IP7G

      Using a T55 "TORX" socket wrench, remove the 8 bolts and flywheel sub-assembly.

  8. Click here

    REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)


    1. A01IN0Q

      Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.

  9. Click here

    REMOVE REAR CRANKSHAFT OIL SEAL


    1. A01IR5EE01

      Using a knife, cut off the lip of the rear crankshaft oil seal.

    2. Using a screwdriver, pry out the rear crankshaft oil seal.

      Note:

      Be careful not to damage the crankshaft.