Click here

ECD SYSTEM (for Swirl Control Valve), Diagnostic DTC:P06C5

Click here
Click here Click here
DTC Code DTC Name
P06C5 Cylinder 1 Glow Plug Incorrect
Click here

DESCRIPTION

Refer to DTC P052F (Click here).

DTC No. DTC Detection Condition Trouble Area
P06C5

Installed glow plug is not compatible with engine for 1.2 seconds.

(3 trip detection logic)

  • Glow plug

  • Glow plug controller assembly
Click here

INSPECTION PROCEDURE

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    REPLACE GLOW PLUG


    1. Replace the glow plug (Click here).

      Tip:

      When DTC P06C5 is stored, an unsupported glow plug may be installed to the vehicle.


  2. Click here

    CHECK WHETHER DTC OUTPUT RECURS (DTC P06C5)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs (Click here).

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    8. Read the DTCs.

      Table 1. Result
      Result Proceed to
      No DTC output A
      DTC P06C5 B

  3. Click here

    REPLACE GLOW PLUG CONTROLLER ASSEMBLY


    1. Replace the glow plug controller assembly (Click here).


  4. Click here

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs (Click here).

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.


  5. Click here

    END