Click here

ECD SYSTEM (for Swirl Control Valve), Diagnostic DTC:P0683

Click here
Click here Click here
DTC Code DTC Name
P0683 Glow Plug Control Module 1 to PCM Communication Circuit
Click here

DESCRIPTION

Refer to DTC P052F (Click here).

DTC No. DTC Detection Condition Trouble Area
P0683

When glow plug controller assembly and ECM cannot communicate via LIN communication.

(3 trip detection logic)

  • Open or short in LIN circuit

  • Glow plug controller assembly

  • ECM
Click here

WIRING DIAGRAM

Refer to DTC P052F (Click here).

Click here

INSPECTION PROCEDURE

Note:

  • When replacing the ECM, the ECM needs Registration and Initialization (Click here).

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tip:

  • When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

  • Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (GLOW PLUG CONTROLLER ASSEMBLY - ECM)


    1. Disconnect connectors of the glow plug controller assembly.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      C96-3 (SI) - C112-74 (LIN) Always Below 1 Ω
      C96-3 (SI) or C112-74 (LIN) - Body ground Always 10 kΩ or higher

  2. Click here

    REPLACE GLOW PLUG CONTROLLER ASSEMBLY


    1. Replace the glow plug controller assembly (Click here).


  3. Click here

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs (Click here).

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.


  4. Click here

    REPLACE ECM


    1. Replace the ECM (Click here).


  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR


    1. Repair or replace the harness or connector.


  6. Click here

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs (Click here).

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.


  7. Click here

    END