ECD SYSTEM (for Swirl Control Valve), Diagnostic DTC:P064C

DTC Code DTC Name
P064C Glow Plug Control Module 1

DESCRIPTION

When it is determined that there is a malfunction in the glow plug control assembly, a malfunction signal is sent via LIN communication. This DTC is stored when the malfunction signal is received by the ECM.

DTC No. DTC Detection Condition Trouble Area
P064C

Preheating control unit internal fault for 1.2 seconds.

(3 trip detection logic)

 Glow plug controller assembly

INSPECTION PROCEDURE

Tech Tips

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. REPLACE GLOW PLUG CONTROLLER


    1. Replace the glow plug controller assembly Click here.


    NEXT

  2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs Click here.

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.


    NEXT

    END