ECD SYSTEM, Diagnostic DTC:P06C5

DTC Code DTC Name
P06C5 Cylinder 1 Glow Plug Incorrect

DESCRIPTION

Refer to P052F Click here.

DTC No. DTC Detection Condition Trouble Area
P06C5

Installed glow plug is not compatible with engine for 1.2 seconds or more

(3 trip detection logic)


  • Glow plug

  • Glow plug controller assembly

INSPECTION PROCEDURE

Tech Tips

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. REPLACE GLOW PLUG


    1. Replace the glow plug Click here.


    NEXT
  2. CHECK WHETHER DTC OUTPUT RECURS (DTC P06C5)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs Click here.

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Turn the ignition switch to ON and wait for 15 seconds or more [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Read the DTCs.

      Result
      Result Proceed to
      No DTC output A
      DTC P06C5 B

    B
    A
  3. REPLACE GLOW PLUG CONTROLLER ASSEMBLY


    1. Replace the glow plug controller assembly Click here.


    NEXT
  4. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs Click here.

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Turn the ignition switch to ON and wait for 15 seconds or more [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.


    NEXT