Click here

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) Radio Receiver Power Source Circuit

Click here
Click here Click here
DTC Code DTC Name
  Radio Receiver Power Source Circuit
Click here

DESCRIPTION

This circuit provides power to the radio receiver assembly.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND)


    1. A01INP6E04

      Disconnect the H1 radio receiver connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H1-7 (E) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H1-4 (B) - Body ground Always 11 to 14 V
      H1-3 (ACC) - Body ground Ignition switch ACC
      Table 1. Text in Illustration
      *1

      Front view of wire harness connector

      (to Radio Receiver Assembly)

  2. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR