AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.

WIRING DIAGRAM

A01INGBE06

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - NO. 1 STEREO JACK ADAPTER)


    1. Disconnect the H115 radio receiver assembly connector.

    2. Disconnect the H104 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H115-2 - H104-1 Always Below 1 Ω
      H115-3 - H104-3
      H115-2 - Body ground Always 10 kΩ or higher
      H115-3 - Body ground
      H115-5 - Body ground

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here