RELAY ON-VEHICLE INSPECTION


  1. CHECK SKID CONTROL RELAY (FR DEICER, BRAKE LP)


    1. Remove the skid control relay from the engine room No. 1 relay block.

    2. A01IS30E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage not applied to terminals 1 and 2 Below 1 Ω
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the skid control relay.

    3. Install the skid control relay.