REAR SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)


    1. Install the rear axle hub and bearing LH Click here.

  2. INSTALL SKID CONTROL SENSOR WIRE


    1. Pass the skid control sensor wire under the flexible hose and connect the skid control sensor wire connector to the skid control sensor.

      Note


      • To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.

      • Do not twist the sensor wire when installing the clamp.

    2. Attach the 2 grommets.

    3. Install the sensor clamp with the nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    4. Install the sensor clamp with the nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    5. A01IRGJE03
      Text in Illustration
      *1 Grommet
      *2 Band Clamp
      *3 Connector
      *a Inside of Vehicle

      Insert the connector and grommet into the inside of the vehicle through the hole in the wheel house.

      Note

      Make sure the band clamp remains on the outside of the vehicle.

    6. A01IRDWE05
      Text in Illustration
      *a Outside of Vehicle

      Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

      Note


      • When pulling out the grommet, do not grip the sensor wire.

      • Fix the grommet in place within the range shown in the illustration.

    7. Connect the skid control sensor wire connector to the vehicle side connector on the rear floor.

  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH


    1. w/o Rear No. 2 Seat:

      Install the deck trim side panel assembly LH Click here.

    2. w/ Rear No. 2 Seat:

      Install the deck trim side panel assembly LH Click here.

  4. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    A01IUDC

    1. Install the tonneau cover.

  5. INSTALL REAR DISC


    1. A01IT27E01
      Text in Illustration
      *1 Matchmark

      Align the matchmarks of the disc and axle hub and install the disc.

      Note

      When replacing the rear disc with a new one, select an installation position where the rear disc has the smallest runout.

  6. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A01IQLJ

      Connect the rear disc brake cylinder with the 2 bolts.

      Torque:
      57 N*m  { 585 kgf*cm, 42 ft.*lbf }

      Note


      • Do not twist the brake hose.

      • Make sure that the bolts are free from damage and foreign matter.

  7. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  8. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.