STEERING ANGLE SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL SPIRAL CABLE SUB-ASSEMBLY


    1. A01ITGQ

      Attach the 3 claws to install the spiral cable.

    2. Connect the connectors to the spiral cable.

  2. INSTALL UPPER STEERING COLUMN COVER

    Note

    If the steering column cover is installed in an incorrect order, it will not be possible to assemble the steering column cover.


    1. A01IRRJ

      Attach the claw and 2 pins to install the upper steering column cover.

  3. INSTALL LOWER STEERING COLUMN COVER


    1. A01IRAC

      Attach the 2 claws and install the steering column lower cover as shown in the illustration.

    2. A01IR2N

      Attach the 4 claws.

    3. A01IPH0

      Attach the claw.

      Tech Tips

      Press the area around the claw to attach it.

  4. ADJUST SPIRAL CABLE SUB-ASSEMBLY


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01IUFO

      Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

    4. A01ITLH

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

      Tech Tips

      The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center.

  5. INSTALL STEERING WHEEL ASSEMBLY


    1. Install the steering wheel assembly Click here.