ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the radiator reservoir cap.

      CAUTION:

      Do not remove the radiator reservoir cap and air release plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

      A01IUC4E01
      Text in Illustration
      *1 Radiator Reservoir Cap *2 Air Release Plug
      *3 Radiator Drain Cock Plug - -

  2. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01IOT2

      Detach the clamp and disconnect the mass air flow meter connector.

    2. Slide the clamp and disconnect the PCV hose from the cylinder head cover sub-assembly.

    3. Slide the clamp and disconnect the air cleaner hose assembly from the turbocharger sub-assembly.

    4. Detach the 4 clamps and remove the air cleaner cap sub-assembly.

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ITZL

      Remove the 3 bolts and air cleaner case.

  6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01IQAJE03

      Disconnect the engine coolant temperature sensor connector.

    2. Using SST, remove the engine coolant temperature sensor and gasket.

      SST
      09817-33190