CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE CAMSHAFT POSITION SENSOR

    A01IR4XE01
    Text in Illustration
    *A for CCo
    *B for DPF

    1. for DPF:

      Detach the wire harness clamp.

    2. Disconnect the camshaft position sensor connector.

    3. Remove the bolt and camshaft position sensor.