Click here

ECM REMOVAL

Click here
Click here Click here
  1. Click here

    PERFORM REGISTRATION


  2. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. Click here

    REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note:

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. Click here

    REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IS0M

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  6. Click here

    REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01IOT2

      Detach the clamp and disconnect the mass air flow meter connector.

    2. Slide the clamp and disconnect the PCV hose from the cylinder head cover sub-assembly.

    3. Slide the clamp and disconnect the air cleaner hose assembly from the turbocharger sub-assembly.

    4. Detach the 4 clamps and remove the air cleaner cap sub-assembly.

  7. Click here

    REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  8. Click here

    REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ITZL

      Remove the 3 bolts and air cleaner case.

  9. Click here

    REMOVE NO. 1 AIR CLEANER INLET


    1. A01IRC4

      Remove the clip.

    2. Detach the 2 claws and remove the No. 1 air cleaner inlet.

  10. Click here

    REMOVE NO. 2 AIR CLEANER INLET


    1. A01IU27

      Remove the bolt and No. 2 air cleaner inlet

  11. Click here

    REMOVE ECM


    1. Disconnect the 2 ECM connectors.


      1. A01ISWU

        Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

        Note:

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    2. A01IRFL

      Remove the 2 bolts and ECM with bracket.

    3. A01IRFA

      Remove the 4 screws and 2 ECM brackets.