ACCELERATOR PEDAL ON-VEHICLE INSPECTION


  1. CHECK ACCELERATOR PEDAL ROD


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

    5. Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

      Standard Voltage (Accel Sens. No.1 Volt %)
      Accelerator Pedal Condition Specified Condition
      Released 8 to 28%
      Depressed 30 to 55%
      Standard Voltage (Accel Sens. No.2 Volt %)
      Accelerator Pedal Condition Specified Condition
      Released 51 to 86%
      Depressed 73 to 98%

      If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.