ENGINE OIL TEMPERATURE SENSOR INSTALLATION


  1. INSTALL ENGINE OIL TEMPERATURE SENSOR


    1. Install a new gasket to the engine oil temperature sensor.

    2. Using a 19 mm deep socket wrench, install the engine oil temperature sensor to the timing chain cover sub-assembly.

      Torque:
      20 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      If the engine oil temperature sensor has been struck or dropped, replace it.

    3. Connect the engine oil temperature sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  3. REMOVE REAR ENGINE UNDER COVER RH


    1. A01IP88

      Install the under cover RH with the 5 clips.

  4. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }