ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01IPWV

      Remove the clip and battery service hole cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IU5G

      Remove the 5 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  3. DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the radiator reservoir cap.

      CAUTION:

      Do not remove the radiator reservoir cap while the engine and radiator are still hot.

      Pressurized, hot engine coolant and steam may be released and cause serious burns.

      A01INZOE01
      Text in Illustration
      *1 Radiator Reservoir Cap *2 Radiator Drain Cock Plug

  4. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01ISEG

      Disconnect the mass air flow meter connector.

    2. Detach the 2 clamps and disconnect the wire harness.

    3. A01IP4V

      Disconnect the 2 clamps.

    4. A01IPUC

      Disconnect the PCV hose.

    5. Loosen the band and remove the air cleaner cap.

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01IQF0

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01INEF

      Disconnect the sensor connector.

    2. A01IOBJE01

      Using SST, remove the sensor and gasket.

      SST
      09817-33190