ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

REMOVE RADIATOR SUPPORT OPENING COVER

1. 

   Remove the 3 clips.

2. Detach the 4 hooks and remove the radiator support opening cover.

DRAIN ENGINE COOLANT

1. Loosen the radiator drain cock plug.

   Tip:

   Collect the coolant in a container and dispose of it according to the regulations in your area.

2. 

   Remove the radiator reservoir cap.

   CAUTION:

   Do not remove the radiator reservoir cap while the engine and radiator are still hot.

   Pressurized, hot engine coolant and steam may be released and cause serious burns.

   Table 1. Text in Illustration

   *1

   Radiator Reservoir Cap

   *2

   Radiator Drain Cock Plug

REMOVE NO. 2 CYLINDER HEAD COVER

1. 

   Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

   Note:

   Attempting to detach both front and rear clips at the same time may cause the cover to break.

REMOVE AIR CLEANER CAP SUB-ASSEMBLY

1. 

   Disconnect the mass air flow meter connector.

2. Detach the 2 clamps and disconnect the wire harness.

3. 

   Disconnect the 2 clamps.

4. 

   Disconnect the PCV hose.

5. Loosen the band and remove the air cleaner cap.

REMOVE AIR CLEANER CASE SUB-ASSEMBLY

1. 

   Detach the wire harness clamp from the air cleaner case.

2. Remove the 3 bolts and air cleaner case.