INTAKE AIR TEMPERATURE SENSOR INSTALLATION


  1. INSTALL INTAKE AIR TEMPERATURE SENSOR


    1. A01ISA8

      Install a new gasket to the sensor.

    2. Using a 22 mm ball joint lock nut wrench, install the sensor.

      Torque:
      34 N*m  { 350 kgf*cm, 25 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench Click here.

    3. Connect the sensor connector.

  2. INSTALL FRONT LOWER BUMPER ABSORBER


    1. A01ISEU

      Insert the 2 hooks of the front lower bumper absorber into the installation holes on the body to install the front lower bumper absorber.

    2. Install the 4 bolts and 4 screws.

    3. A01IT8Z

      Install the 2 clips.

  3. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IUIX

      Install the No. 1 engine under cover with the 10 clips and 6 bolts.