ECM REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IQMS

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01ISEG

      Disconnect the mass air flow meter connector.

    2. Detach the 2 clamps and disconnect the wire harness.

    3. A01IP4V

      Disconnect the 2 clamps.

    4. A01IPUC

      Disconnect the PCV hose.

    5. Loosen the band and remove the air cleaner cap.

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01IPXX

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  8. REMOVE NO. 1 AIR CLEANER INLET


    1. A01IRFN

      Remove the clip.

    2. Detach the 2 claws and remove the No. 1 air cleaner inlet.

  9. DISCONNECT NO. 2 AIR CLEANER INLET


    1. A01IT65

      Remove the bolt and disconnect the No. 2 air cleaner inlet from the vehicle body.

  10. REMOVE ECM


    1. A01IU8V

      Detach the wire harness clamp.

    2. Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

      Note

      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    3. A01IQ3I

      Remove the 2 bolts and ECM.

    4. A01ISQ3

      Remove the 2 screws and No. 1 ECM bracket.

    5. A01IS74

      Remove the 2 screws and No. 2 ECM bracket.