Click here

THROTTLE BODY REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE BATTERY SERVICE HOLE COVER


    1. A01IU5G

      Remove the 5 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. Click here

    REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IU5G

      Remove the 5 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  3. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  4. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  5. Click here

    DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      Tip:

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. A01INZOE01

      Remove the radiator reservoir cap.

      CAUTION:

      Do not remove the radiator reservoir cap while the engine and radiator are still hot.

      Pressurized, hot engine coolant and steam may be released and cause serious burns.

      Table 1. Text in Illustration
      *1 Radiator Reservoir Cap *2 Radiator Drain Cock Plug
  6. Click here

    REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note:

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  7. Click here

    REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01ISEG

      Disconnect the mass air flow meter connector.

    2. Detach the 2 clamps and disconnect the wire harness.

    3. A01IP4V

      Disconnect the 2 clamps.

    4. A01IPUC

      Disconnect the PCV hose.

    5. Loosen the band and remove the air cleaner cap.

  8. Click here

    REMOVE THROTTLE BODY ASSEMBLY


    1. A01IUOW

      Disconnect the throttle body connector and 2 water hoses.

    2. A01IQIG

      Remove the 2 bolts, 2 nuts and throttle body.

    3. Remove the gasket.