FRONT BUMPER (for Standard) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01NKI4

      Remove the 4 clips and engine room side cover.

  2. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01NJLS

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01NJMT

      Remove the 6 clips and cool air intake duct seal.

  4. REMOVE HOOD CENTER CUSHION


    1. A01NJS8

      Remove the 2 hood center cushions.

  5. REMOVE FRONT BUMPER ASSEMBLY


    1. A01NLAXE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A01NJ4KE01

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A01NJ0Z

      Remove the screw and front bumper seal bracket.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01NM67

      Remove the 2 bolts and 2 screws.

    5. Using a clip remover, remove the 5 clips.

    6. A01NKU8

      Disengage the 3 claws.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A01NN2A

      Using a moulding remover, disengage the claw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. A01NJD1

      Disengage the claw and disconnect the front bumper assembly as shown in the illustration.

    9. Disconnect the headlight cleaner hose. (w/ Headlight Cleaner System)

      Note

      Prepare a drain pan or a piece of cloth in case washer fluid leaks.

    10. Disconnect each connector and remove the front bumper assembly.