HEADLIGHT ASSEMBLY (except LED Headlight) REASSEMBLY


  1. INSTALL FRONT BUMPER BAR REINFORCEMENT


    1. A01NK0P

      Engage the 2 guides to temporarily install the front bumper bar reinforcement.

    2. Install the front bumper bar reinforcement with the 2 screws.

  2. INSTALL FRONT TURN SIGNAL LIGHT BULB


    1. Install the front turn signal light bulb to the front turn signal light socket.

    2. A01NK5L

      Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration and install them as a unit.

  3. INSTALL NO. 2 HEADLIGHT BULB (for Halogen Headlight)


    1. A01NKWE

      Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.

      Note


      • Do not touch the bulb glass.

      • Correctly align the 3 tabs on the bulb when installing it to the headlight assembly.

  4. INSTALL DISCHARGE HEADLIGHT BULB (for HID Headlight)


    1. Set the discharge headlight bulb to the headlight unit.

      Note

      Do not touch the bulb glass.

    2. A01NNANE01

      Lock the set spring to install the discharge headlight bulb as shown in the illustration.

  5. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (for HID Headlight)


    1. A01NNCEE01
      Text in Illustration
      *a Red Line

      Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration to connect it.

      Note


      • Check that the O-ring is installed on the headlight light control ECU sub-assembly.

      • Check that the O-ring is not damaged or contaminated with foreign matter. If there is any damage, replace the O-ring with a new one.

      • Do not pull the headlight light control ECU sub-assembly with the socket connected.

    2. Check that the red line on the output harness is not twisted and store the harness in the headlight assembly securely so that the output harness is not pinched.

    3. A01NJVPE01
      Text in Illustration
      *a Lock Mark

      Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration until the lock marks are aligned to install it.

      Note


      • To prevent incomplete installation, make sure to fully push in and turn the headlight light control ECU sub-assembly until the lock marks are aligned.

      • Do not apply excessive force using a tool.

  6. INSTALL NO. 1 HEADLIGHT BULB


    1. A01NI2B

      Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.

      Note


      • Do not touch the bulb glass.

      • Correctly align the 3 tabs on the bulb when installing it to the headlight assembly.

    2. A01NJ5J

      Connect the connector.