HEADLIGHT ASSEMBLY (except LED Headlight) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE REAR DECK FLOOR BOX


    1. A01NIBL

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT BUMPER ASSEMBLY (for Standard)

    Click here

  5. REMOVE FRONT BUMPER ASSEMBLY (for Sport Package)

    Click here

  6. REMOVE FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY


    1. A01NIK8E01
      Text in Illustration
      *1 Hood to Cowl Top Seal

      Disengage the clip and the hood to cowl top seal from the front fender top reinforcement sub-assembly LH.

    2. A01NIDU

      Remove the clip.

    3. Disengage the 3 clips and 2 guides, and remove the front fender top reinforcement sub-assembly LH.

  7. REMOVE HEADLIGHT ASSEMBLY

    CAUTION:

    for HID Headlight:

    The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.


    1. A01NIOU

      Remove the 3 bolts and screw.

    2. A01NI4JE01
      Text in Illustration
      *A for Halogen Headlight
      *B for HID Headlight

      Disengage each clamp.

    3. Disconnect each connector and remove the headlight assembly.