POWER MIRROR CONTROL SYSTEM Power Mirror cannot be Adjusted with Power Mirror Switch

SYSTEM DESCRIPTION

The multiplex network master switch assembly detects the mirror adjust switch status and sends the signal to the main body ECU (multiplex network body ECU) via LIN communication. The main body ECU (multiplex network body ECU) then sends the mirror adjust switch signal to each outer mirror control ECU (both driver and front passenger sides) via CAN communication. On receiving the signal, each outer mirror control ECU operates the vertical and horizontal mirror motors to adjust the mirror surface position.

WIRING DIAGRAM

A01NNDAE01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Use the intelligent tester to check if the CAN communication system is functioning normally Click here.

      OK
      CAN communication DTC is not output.

    NG
    OK
  2. CHECK LIN COMMUNICATION SYSTEM


    1. Use the intelligent tester to check if the LIN communication system is functioning normally Click here.

      OK
      LIN communication DTC is not output.

    NG
    OK
  3. READ VALUE USING INTELLIGENT TESTER (OUTER MIRROR SWITCH ASSEMBLY)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Master Switch / Data List.

    5. Read the Data List according to the display on the intelligent tester.

      Master Switch
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Mirror Selection SW (R) Mirror select switch signal for RH mirror / ON or OFF

      ON: Switch in R position

      OFF: Switch off or in L position

      -
      Mirror Selection SW (L) Mirror select switch signal for LH mirror / ON or OFF

      ON: Switch in L position

      OFF: Switch off or in R position

      -
      Mirror Position SW (R) Mirror adjust switch signal (right) / ON or OFF

      ON: Mirror adjust switch pressed right

      OFF: Mirror adjust switch not pressed right

      Check with the mirror select switch in any position except neutral
      Mirror Position SW (L) Mirror adjust switch signal (left) / ON or OFF

      ON: Mirror adjust switch pressed left

      OFF: Mirror adjust switch not pressed left

      Check with the mirror select switch in any position except neutral
      Mirror Position SW (Up) Mirror adjust switch signal (up) / ON or OFF

      ON: Mirror adjust switch pressed up

      OFF: Mirror adjust switch not pressed up

      Check with the mirror select switch in any position except neutral
      Mirror Position SW (Dwn) Mirror adjust switch signal (down) / ON or OFF

      ON: Mirror adjust switch pressed down

      OFF: Mirror adjust switch not pressed down

      Check with the mirror select switch in any position except neutral
      OK
      On the intelligent tester screen, ON or OFF is displayed for each item according to the table above.

    NG
    OK
  4. REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY


    1. Replace the multiplex network master switch assembly Click here.


    NEXT
  5. CHECK ELECTRICAL REMOTE CONTROL MIRROR FUNCTION


    1. Check if the mirror surface position can be adjusted by operating the mirror adjust switch.

      OK
      Electrical remote control mirror function is normal.

    NG
    OK