Click here

POWER BACK DOOR CONTROL SWITCH INSPECTION

Click here
Click here Click here
  1. Click here

    INSPECT POWER BACK DOOR CONTROL SWITCH


    1. Check the operation of the control switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        3 - 4 Power back door control switch pushed Below 1 Ω
        3 - 4 Power back door control switch not pushed 10 kΩ or higher
        Table 1. Text in Illustration
        *1

        Component without harness connected

        (Power Back Door Control Switch)

        If the result is not as specified, replace the power back door control switch.

    2. Check that the switch illuminates.


      1. Apply auxiliary battery voltage to the power back door control switch and check that the switch illuminates.

        OK
        Measurement Condition Specified Condition

        Auxiliary battery positive (+) → terminal 2

        Auxiliary battery negative (-) → terminal 5

        		 Illuminates

        If the result is not as specified, replace the bulb.