Click here

BACK DOOR OPENER SWITCH INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL BACK DOOR OPENER SWITCH ASSEMBLY


    1. A01NLP7

      Install the back door opener switch assembly.

  2. Click here

    INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. Install 2 bolts.

    2. Install 2 stud bolts.

    3. Install 2 new back door outside garnish clips and 4 new gaskets on the back door outside garnish subassembly.

    4. A01NLGT

      Engage the 2 clips to install the back door outside garnish sub-assembly.

    5. Install the 4 nuts.

      4.9 N*m 50 kgf*cm 43 in.*lbf

    6. Connect each connector.

  3. Click here

    INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A01NN8ME01

      Engage the 2 claws and 16 clips to install the back door trim panel assembly.

      Table 1. Text in Illustration
      *1 2-piece Type Clip

    2. Install the 2 screws.

  4. Click here

    INSTALL BACK DOOR SERVICE HOLE COVER LH


    1. A01NLZM

      Engage the 5 claws to install the back door service hole cover LH.

  5. Click here

    INSTALL BACK DOOR SERVICE HOLE COVER RH


    1. A01NI3K

      Engage the 5 claws to install the back door service hole cover RH.

  6. Click here

    INSTALL BACK DOOR UPPER TRIM COVER LH


    1. A01NLU1

      Engage the 2 claws to install the back door upper trim cover LH.

  7. Click here

    INSTALL BACK DOOR UPPER TRIM COVER RH


    1. A01NIGH

      Engage the 2 claws to install the back door upper trim cover RH.

  8. Click here

    INSTALL NO. 2 ROOM LIGHT ASSEMBLY


    1. Connect the connector.

    2. A01NNF3

      Engage the claw to install the No. 2 room light assembly.

  9. Click here

    INSTALL BACK DOOR LOCK COVER


    1. A01NLEF

      Engage the 4 claws to install the back door lock cover.

  10. Click here

    INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)


    1. A01NJWD

      Engage the 6 claws to install the back door finish cover LH.

  11. Click here

    INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)


    1. A01NL82

      Engage the 4 claws to install the back door trim base.

  12. Click here

    INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)


    1. A01NKZ2

      Engage the 6 claws to install the back door finish cover RH.

  13. Click here

    INSTALL DOOR PULL HANDLE WITH SWITCH (w/ Power Back Door)


    1. Connect the connector.

    2. A01NKO5

      Engage the 6 claws to install the door pull handle with switch.

  14. Click here

    INSTALL TONNEAU COVER SUB-ASSEMBLY