AIR CONDITIONING PRESSURE SENSOR REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Turn the A/C switch on.

    2. Operate the A/C with the setting temperature at 25°C (77°F) and the blower level at LO for 10 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

    3. Turn the power switch off.

    4. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  3. REMOVE REAR DECK FLOOR BOX


    1. A01NIBL

      Remove the 3 clips and the rear deck floor box.

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER


    1. A01NKI4

      Remove the 4 clips and engine room side cover.

  6. REMOVE AIR CONDITIONING PRESSURE SENSOR


    1. A01NKKL

      Disengage the clamp.

    2. A01NLD3

      Disconnect the connector.

    3. Remove the air conditioning pressure sensor.

      Note

      Do not deform the piping.