FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE REAR DECK FLOOR BOX


    1. A01NIBL

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE


    1. A01NJ04

      Disengage the 7 claws, 4 clips and guide, and remove the front door scuff plate LH.

      Tech Tips

      A part of the clip remains on the vehicle side.

    2. w/ Illumination:


      1. Disconnect the connector.

  5. REMOVE REAR DOOR SCUFF PLATE


    1. A01NIFR

      Disengage the 6 claws, 3 clips and guide, and remove the rear door scuff plate LH.

  6. REMOVE LOWER CENTER PILLAR GARNISH


    1. A01NKW9

      Disengage the 2 claws and 5 clips, and remove the lower center pillar garnish LH.

  7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01NIAG

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  8. REMOVE CENTER PILLAR GARNISH


    1. A01NKCZ

      Remove the 2 screws.

    2. Using a clip remover, disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar garnish LH and remove the center pillar garnish LH.

  9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01NN4U

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A01NIPH

      Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect each connector.

    4. A01NJ1L

      Remove the 2 bolts and front seat outer belt assembly.

  10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01NMNH

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.