CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly with the 10 hooks.

      A01NIUM

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    4. Install the 10 bolts.

      Torque:
      14 N*m  { 140 kgf*cm, 10 ft.*lbf }

    5. Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure from Install Roof Headlining Assembly Click here.

  3. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.