Click here

HEADUP DISPLAY INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL COMBINATION METER MIRROR ECU


    1. A01NMDE

      Install the combination meter mirror ECU with the 4 screws.

      Note:

      • Make sure that the ECU is installed securely.

      • Do not drop the screws.

    2. Engage the clamp.

    3. Connect the connector.

    4. A01NKXFE01

      Insert the No. 1 heater to register duct in the order indicated in the illustration to temporarily install it.

    5. A01NJ4B

      Install the No. 1 heater to register duct with the 2 screws.

    6. A01NKE8

      Connect the connectors.

  2. Click here

    INSTALL COMBINATION METER ASSEMBLY


    1. Connect each connector.

    2. A01NN6B

      Install the combination meter assembly with the 2 screws.

  3. Click here

    INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL


    1. A01NKYF

      Engage the 4 clips and 2 guides.

    2. Install the No. 1 instrument cluster finish panel with the 2 clips and 2 screws.

  4. Click here

    INSTALL NO. 2 INSTRUMENT PANEL HOLE COVER

    Tip:

    Use the same procedure as for the No. 1 instrument panel hole cover.

  5. Click here

    INSTALL NO. 1 INSTRUMENT PANEL HOLE COVER


    1. A01NLJ7

      Engage the 2 claws to install the No. 1 instrument panel hole cover.

  6. Click here

    INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A01NMBT

      Engage the 2 claws to close the cover as shown in the illustration.

  7. Click here

    INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A01NLSK

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  8. Click here

    INSTALL INSTRUMENT PANEL GARNISH LH


    1. A01NI52

      Engage the 6 clips to install the instrument panel garnish LH.

  9. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    • Make sure that the cable has been disconnected from the negative (-) battery terminal for at least 2 seconds before reconnecting the cable.

    • Reset the auto tilt away function setting to the previous condition by changing the customize parameter (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  10. Click here

    INSTALL REAR DECK FLOOR BOX


    1. A01NIBL

      Install the rear deck floor box with the 3 clips.

  11. Click here

    INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)


    1. Inspect the suspension control system (Click here).