Click here

THEFT DETERRENT SYSTEM (w/o Intrusion Sensor) ECU Power Source Circuit

Click here
Click here Click here
DTC Code DTC Name
  ECU Power Source Circuit
Click here

DESCRIPTION

This circuit provides power for main body ECU (multiplex network body ECU) operation.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. A01NL6NE01

      Disconnect the 2F, 2K and 2D instrument panel junction block assembly and A main body ECU (multiplex network body ECU) connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2F-40 - A-30 (BECU) Always Below 1 Ω
      2K-1 - A-31 (ALTB) Always Below 1 Ω
      2D-6 - A-11 (GND1) Always Below 1 Ω
      Table 1. Text in Illustration
      *1

      Component without harness connected

      (Instrument Panel Junction Block Assembly)

      		 *2

      Component without harness connected

      (Instrument Panel Junction Block Assembly)
      *3

      Component without harness connected

      (Instrument Panel Junction Block Assembly)

      		 *4

      Front view of wire harness connector

      (to Main Body ECU (Multiplex Network Body ECU))

  2. Click here

    CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (POWER SOURCE)


    1. A01NJMRE01

      Reconnect the 2D instrument panel junction block assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A-30 (BECU) - Body ground Power switch off 11 to 14 V
      A-31 (ALTB) - Body ground Power switch off 11 to 14 V
      Table 2. Text in Illustration
      *1

      Front view of wire harness connector

      (to Main Body ECU (Multiplex Network Body ECU))

      		 - -

  3. Click here

    CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BODY GROUND)


    1. A01NJMRE02

      Reconnect the 2F and 2K instrument panel junction block assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-11 (GND1) - Body ground Always Below 1 Ω
      Table 3. Text in Illustration
      *1

      Front view of wire harness connector

      (to Main Body ECU (Multiplex Network Body ECU))

      		 - -

  4. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. Click here

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY